• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Vacuum Line on a 948

Share this page

M

mxp01

Jedi Warrior
Country flag
Offline
All:

I have a 948 engine with the H1 carbs. There is a hard vacuum advance line that runs from the distributor to the base of the carb. It has a small ferrule fitting at the carb connection. Does anyone know the size of that ferrule fitting?

Thanks,

MXP
 
I thought it was the opposite. Threaded end on distributor and rubber connection to carbs. My H1 carbs are in a box somewhere so cannot be sure
 
Threaded at the front carb and distributor. MXP are you looking for thread size or wrench size? I have an original out in the garage I can dig out.
 
Back
Top