• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Universal joints

Share this page

Bugeyze

Bugeyze

Member
Country flag
Offline
Is there a correct position for the grease nipples on prop' shaft universal joints? Should they point towards or away from the shaft?
 
I have always done towards the shaft. A little easier to get to after install.
 
Latest ones I got from Moss recently had the nipple in the end of one of the bearing cups. Seems like a logical improvement.
 
Nipple in the end of the cross not a good idea. Poor balance and road debris can break it off. Whether aimed toward the shaft or yoke is a matter of preference and access considerations but make sure it is under compression when the drive shaft is loaded.
 
Thanks for input, I will mount them toward the shaft.

Stan, I'm not sure what you mean, but make sure it is under compression when the drive shaft is loaded.
 
The driveshaft rotates in a clockwise direction when viewed from the front so be sure the nipple is being squeezed by the driving yoke against the driven yoke.
 
Back
Top