-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
turning over an engine sitting for years ?
- Thread starter beaulieu
- Start date
Share this page
Exotexs
Jedi Knight
Offline
and don't forget a 3/4" to 1/2" socket adapter unless you have both wrenches.
This brings me to the famous argument of Crank Bolt Removal:
Loosening the Bolt: (to replace the damper, for example).
that's simple to do because you are turning the wrench counter-clockwise, (and the engine turns clockwise), and usually a good smack to the wrench will loosen the bolt.
BUT: how do you TIGHTEN the BOLT to proper torque? The engine will eventually start to turn with you as you tighten. In fact, I only torqued mine as far as I could, i.e., until the engine started turning. I don't think it is up to spec. I'm always worried that the Bolt is going to rotate freely one day, straight through the radiator!
Ex
This brings me to the famous argument of Crank Bolt Removal:
Loosening the Bolt: (to replace the damper, for example).
that's simple to do because you are turning the wrench counter-clockwise, (and the engine turns clockwise), and usually a good smack to the wrench will loosen the bolt.
BUT: how do you TIGHTEN the BOLT to proper torque? The engine will eventually start to turn with you as you tighten. In fact, I only torqued mine as far as I could, i.e., until the engine started turning. I don't think it is up to spec. I'm always worried that the Bolt is going to rotate freely one day, straight through the radiator!
Ex
R
RonMacPherson
Guest
Guest
Offline
An easy quick way....
remove the spark plugs. Fill the combustion chambers up, with cord, you know good old fabric cord. Stuff as much down in as you can, leaving a trail to pull it out of the hole.
This acts as s "block" filling up the space above the piston and combustion chamber. The engine may crank a tiny bit, but not usually if you've got more than one chamber filled.
Then when done, remove the cord, install the plugs, fire it up and drive away.......
Voila!
remove the spark plugs. Fill the combustion chambers up, with cord, you know good old fabric cord. Stuff as much down in as you can, leaving a trail to pull it out of the hole.
This acts as s "block" filling up the space above the piston and combustion chamber. The engine may crank a tiny bit, but not usually if you've got more than one chamber filled.
Then when done, remove the cord, install the plugs, fire it up and drive away.......
Voila!