• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Tub Almost ready to come off [pics]

Share this page

M

Miser

Senior Member
Offline
I plan on pulling off the tub this weekend. I am going to wield supports to the inside of the doors and pull off the tub and put it on a dolly then off to the sandblasters!

TR6Tub005.jpg


TR6Tub001.jpg


TR6Tub006.jpg
 
Great job. Keep the before and after pics of the body and frame coming.
 
sand blast or do you mean Soda blast or media blast,

you sand blast that body and you will warp the crap out of the pannels,

I know cause I warped the trunk deck and had to buy another one

unless you like lots of bondo on the car then sand blast it

Hondo
 
yes it's Media blast. On another note Can anyone list the points at which the tub is held to the frame. I have taken the ones in the engine bay off but I have no idead where the ohters are.
 
TRF sells a body mounting kit that includes new everything for screwing the body down, including many shims. Try to remember where the shims might be and mark down. These bodies often were shimmed for proper fitting.
 
Put the shims from each mounting location in a separate bag and mark the bag as to where they came from. It will help when putting things back together. It won't necessarily be the same, but a good starting point.
 
Miser said:
yes it's Media blast. On another note Can anyone list the points at which the tub is held to the frame. I have taken the ones in the engine bay off but I have no idead where the ohters are.
Click to expand...

At the back, there is the tire hold down, and the two ends of the frame.

Inside the passenger area, there are two brackets on each side along the outside rail, each has several bolts.

Toward the center, along the drive shaft tunnel, there is one on each side.
 
Miser

Pics of mine from left to right = rear to front to go along with Darrell's description above

100_2905.jpg



Cheers,
Tush
 
Miser said:
tdskip said:
Good progress.

What are you going to prime the sandblasted body with?
Click to expand...

Not sure my paint guy is going to do that. He did my MG also.
Click to expand...

Ask! Personally, I'd <span style="text-decoration: underline">insist</span> on an epoxy sealer to make sure no moisture can get to the metal.
 
Back
Top