• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR6 TR5/6 Engine Mount/Chassis Brackets Assistance Please.

Share this page

M

malbaby

Jedi Warrior
Country flag
Offline
Planning install of 6cyl TR engine into my TR4A project car and require the brackets that are welded onto the chassis.

OR....accurate dimensions to make my own.
 
malbaby said:
Planning install of 6cyl TR engine into my TR4A project car and require the brackets that are welded onto the chassis.

OR....accurate dimensions to make my own.
Click to expand...
Will see if I can get some dimensions for you tomorrow.
 
Malbaby.... here's the dimensions that I came up with in order to make the TR6 brackets. If I missed anything or something does not look right just let me know and I'll get/verify a measurement.
I did not get any dimensions for the hole size/placement. I would use the rubber motor mount that attaches to the engine as a template to place the holes.
Hope this helps...

EDIT..... I reposted the drawing since a dimension was left off but is now updated
Finished Mount
TR6 Motor Mount 1.jpg

Drawing detail
TR6 Motor Mount.jpg
 
Last edited:
Back
Top