tmc
Senior Member
Offline
I'm working on installing the door latches/hardware. When I position the striker plate in the holes/"nut plates" provided, my door sticks out more than a 1/4 inch at the back edge when latched. Without the striker plate in there, the doors fit very well, the hinges are right and tight and the door latch assembly can't be "adjusted". The holes in the door jamb/post give some "wriggle" room but nowhere near enough. I got the striker plates from Moss. I can't find the old ones in my parts heap, so can't tell if the new ones are wrong. I'm stumped. Jim Beam and I are going to think about it on the porch for awhile.
Suggestions?
Suggestions?