• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A TR3A Brake drum removal: RUST! [Arghhhhhh]

Share this page

I've found this is another good use for the copper-faced hammer used for wire wheels.

Scott
 
Moseso said:
Then, the whole thing came off, shoes, hardware, cylinder and all.
Click to expand...
What did you do about the hold-down pins? Or do you have the 10" brakes without hold down pins?
 
TR3driver said:
Moseso said:
Then, the whole thing came off, shoes, hardware, cylinder and all.
Click to expand...
What did you do about the hold-down pins? Or do you have the 10" brakes without hold down pins?
Click to expand...

I did it the same way as Moses on a TR4 - the pins are no issue unless you are trying to save them - the little clips will come off pretty easily, but will likely be deformed and difficult to reuse. Then again since everything is rusty anyway they probably need replacement anyway.
 
TR3driver said:
Moseso said:
Then, the whole thing came off, shoes, hardware, cylinder and all.
Click to expand...
What did you do about the hold-down pins? Or do you have the 10" brakes without hold down pins?
Click to expand...
That is exactly what I have. Although, there must be a way to deal with the hold-down pins, where they stick through the back of the backing plate.
 
Back
Top