-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A Tr3 club Toyota conversion
- Thread starter prb51
- Start date
Share this page
Fastguy1955
Freshman Member
Offline
Thank You very MUCH!!!!!
Offline
Was Rube Goldberg involved in this conversion? Was this done just to prove it could be done, or was there another message here? I wouldn't trust the shaft alignment on a bet. How about metal fatigue due to welding on the two different compounds of aluminum? Oh well, to each his own.
OP
prb51
Luke Skywalker
Offline
PAUL161 said:Was Rube Goldberg involved in this conversion? Was this done just to prove it could be done, or was there another message here? I wouldn't trust the shaft alignment on a bet. How about metal fatigue due to welding on the two different compounds of aluminum? Oh well, to each his own.
Paul,
I'll try to answer this in a straightfwd manner.
1. economics- The Toyota 5 speed, new driveshaft for the same, and the German Bastuck rack and pinion that are now on my car cost less than the HVDA kit alone. (the HVDA is a great kit)
2. The alignment isn't that hard and the welding of the bell is done by a pro at a fabrication/machinest shop. If the Toy mainshafts slides easily thru the properly aligned clutch into the crank and you tighten the housing down and everything moves nicely you are within spec...it's not the space shuttle.
3. Any master welder can weld similar alloys of this thickness, problems are only an issue on very thin alloy dissimilar welds with little weld bearing surface.
4. I only have 2500 miles on the tranny conversion, which works flawlessly, but I'll let you know if there are issues.
5. If your question is "Why do something yourself when someone else can do it for you", I can't answer that one.