• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR6 TR-6 Fuel Injection Manifold

Share this page

T

TheSearcherMan

Jedi Trainee
Offline
Anybody know anyone who is making a nice looking manifold to put EFI on a TR-6? The one I like isn't made anymore. And I ain't spending 2k for just the manifold.
 
Ahhhh, once again the quest begins for the elusive Holy Grail of TR6's. Just in time for the new Indiana Jones movie to be released.

I'll bet that when he's in the underground tombs, you will see a stockpile of the original manifolds that were stolen long, long ago.....right beside the 100,000 mile thrust washers.

But pay close attention, as the tombs were all wired by Lucas and it's a little dark in there.
 
2k is cheap - you should see what TWM charge.

There's always TBI. sub 2k all up.
 
Well, Lucas I may be installing one of yours soon. And, in regards to the thrush washers. My opinion is, if the clutch is right, you will never wear out the washers, excess pressure due to junk clutches wears out the thrush washers. Now, that said, be very careful, the magic clutch is not without its little problems........, which could be big problems.......
 
My thoughts too, 2k is cheap..........
Regards
Craig
 
Actually you can buy a MIG, a pillar drill, a tubing notcher and a power bandsaw for under $1000. $250 for a welding class and $200 in materials and you can DIY for less than the $2k mentioned.

Sell the tools afterwards and you'll be well ahead. Here's a primer...

https://www.sdsefi.com/techinta.htm
 
Piece of cake!
 
I read the cost as $200. $2,000 would be on the pricey side.
 
Back
Top