• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Torque specification on large pitman arm nut

Share this page

S

sp53

Yoda
Country flag
Offline
I have been looking around for Torque specification on large pitman arm nut, but cannot find any. I am thinking about 80 to 100 should work?
 
Sounds good to me. I think Mark Macy gives 80 ftlb on his web site, but I used 100 and it seemed to work fine.
 
Back
Top