• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Tips for installing intake manifold plugs in a stock Bugeye?

Share this page

I

ichthos

Darth Vader
Country flag
Offline
Been a while since I have been on the forum. Nice to be back. I need some help. While driving, one of the plugs in the intake manifold just popped out. Brought my Bugeye to a quick stop. Anyone ever heard of this happening before? I am going to be reinstalling both plugs-anyone have any tips for me on doing this? Any help is greatly appreciated.
Kevin
 
Did the car back fire?
 
No, just a loss of power, and then it would not start again. At the time I didn't even think to check for a missing plug.
 
I've never removed those plugs so I have no idea how they fit. I would assume they are tight enough that you could use the bearing adhesive that is made by loc-tite.
 
Never heard of this before. Where did you find plugs.
I would use a good dose of JB Weld around the plugs to make sure they stay in place
 
Maybe peen them after installing (if that is the correct term) to help keep them in. I've heard of people doing this to the freeze plugs in the block.
 
Kevin,
Welcome back! I don't know the real name, but I used mini freeze plugs in mine and just pressed them in.
Rut
 
Back
Top