• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Tenex studs / top fasteners

Share this page

Jeepster

Jeepster

Jedi Trainee
Country flag
Offline
Would anyone have a few pics to show which tenex stud fits where to the body of my recently restored BJ8?

i see the parts supplies sell a variety of types and lengths but I have no idea which goes where?
 
Look at the female recepticals on : The Top,On the boot cover and the tonnue cover they will tell you. I think off the top of my hea the are all use the same threaded male part but not sure
 
Keoke said:
Look at the female recepticals on : The Top,On the boot cover and the tonnue cover they will tell you. I think off the top of my hea the are all use the same threaded male part but not sure
Click to expand...

Unfortunately I don't have those items as yet and also the threaded part seems to be available in different lengths? The padded dash top also requires a couple?
 
Jeepster said:
Unfortunately I don't have those items as yet and also the threaded part seems to be available in different lengths?


The padded dash top also requires a couple? These are associated with the tonnue cover.
Click to expand...
 
Then it might be more productive to wait until you get them , because after market fasteners and original hardware differ slightly.

But if you are buying aftermarket covers you can get the correct fastener with each order perhaps if you request them.??
 
Last edited:
Back
Top