• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Taillight wiring

Share this page

jaegzie

jaegzie

Jedi Hopeful
Country flag
Offline
Ok keep in mind I am not in any way good with wiring or really fully understand everything.

When wiring in the taillights it doesn't matter which side the wires go into except the ground. But looking at the plate with the light the two wires from the car can go on either side of the bottom correct. One on each side though.
 

Attachments

  • image.jpg
    image.jpg
    184.2 KB · Views: 64
Yes, it does make a difference. The bulbs are dual filament, one for tail and one for brake. The thicker filament is for the brake.
Insert the bulb (like a #1157), it can only go in one way and lock it in. Turn on the tail lights (outer knob on the ignition switch, one click), then touch one of the wires to one of the lamp connections. Then touch it to the other lamp connection. Then connect the wire to the one that is less bright....that is for the taillights. Connect the other wire to the other connection...that is for the brake lights. Make sure you have a good ground, or nothing works with these lamp sockets.
Scott in CA
 
When assembling the electrical circuits I use a inline fuse holder that you can get at any parts store with a 10 or 15 amp fuse in it. Put one end of it under the nut on your battery clamp and use a hose clamp to clamp the other end to your battery post. You then have the whole system fused in case you accidentally short something out. Saves letting the smoke out of some expensive components and wiring.

Kurt.
 
Back
Top