• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Starter Windings

Share this page

vette

vette

Darth Vader
Silver
Country flag
Offline
Does anyone know what the total resistance of the starter field windings is suppose to be? Was getting ready to install starter on engine then reinstall engine, but the starter was so cruded up I had to take it apart to clean it. I think everything will be in order but since I removed the windings I figure I should check them out before I put them back in. thanks again. Dave.
 

Attachments

  • Copy of DSCF2004.JPG
    Copy of DSCF2004.JPG
    97.5 KB · Views: 62
You will be ahead both in function and cost by purchasing and installing a gear reduction starter...
 
Hi big6,
I'm not sure I can agree about the cost part, so far this thing hasn't cost me anything. But I have come into alittle dilemma. I broke one of the "brush tension springs". You would think the aftermarket would have these covered because they are pretty vulnerable and would be needed often. But all the usual suspects have them listed as N/A. A H SPARES list a spring for the Dynamo but it is not the same spring.
 
Back
Top