mjobrien
Jedi Trainee
Offline
I’m getting ready (next few weeks) to start my BN1 after 18 years and a ground up rebuild. On the wiring side I had thought it best to blank off all the wires not used for starting (Fuel gauge, lights, horns, signals, O/D, wiper, heater). I did connect the tachometer, oil/water, all ignition circuits, fuel pump, battery switch, chassis grounds, generator, relay, voltage regulator.
I was wondering is this good route to go when you just have a chassis?
Any pointes would be appreciated, on this as well as any other start up pointers.....
Michael.
I was wondering is this good route to go when you just have a chassis?
Any pointes would be appreciated, on this as well as any other start up pointers.....
Michael.