-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A Squeaking Clutch when hot
- Thread starter Ariddick
- Start date
Share this page
Offline
Can you get someone to do that whilst you carefully check the crank pulley movement on the front. You may wish to disconnect the fan belt first to be safe. If the pulley moves forward a little it could be your crank thrust washers ?
Which is what I think Steve is alluding to ?
Which is what I think Steve is alluding to ?
OP
Ariddick
Member
Offline
Not a fresh rebuild. Fairly certain it just has the stock rear scroll.
I did check crank end float and it was at 0.0085”
That’s not too far out but maybe enough where I’m getting a rub. Replacing thrust washers would be easy enough.
Wish I had inspected the block closer when I had the flywheel off.
I did check crank end float and it was at 0.0085”
That’s not too far out but maybe enough where I’m getting a rub. Replacing thrust washers would be easy enough.
Wish I had inspected the block closer when I had the flywheel off.