• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Spin-oil filter, which filters?

Share this page

I see the K&N HP2004 I've been using sells for $15.99 at my local Oreilley chain auto parts store - compared to $5.81 for the master pack Wix. That's $10 for the hex nut on the end (which I found unusable). The filters appear to be nearly identical inside in the comparisons.
 
I have switch to the K&N on my 100/4, and it seems to provide slightly higher oil pressure than the Fram. Just an observation.
 
Oil filters aren't supposed to be torqued to 200 ft-lbs; some say to 'tighten 1.5 turns after gasket makes contact' or similar. I tighten mine 'wrist tight;' and they come off by hand as well (if they don't, you've over-tightened). I also use Dow silicone #4 on the gasket, because that was recommended for aircraft oil filters (but I'll use clean engine oil in a pinch).
 
Just checked - my K&N I'm about to install has a graphic that says "+3/4" for tightening. I usually mark my filters with the date installed and 1 2 3 4 around the periphery. 3/4 of a turn is about all they take before being too tight to turn any more by hand. I always have to use an oil filter wrench to get them off.

FWIW K&N lists the threads for the 2004 as 3/4-16. Pretty much any filter with those threads will work.

PS - here it is installed with my extra sandwich plate for the [semi-useless] oil temp gauge. Is this a good choice for the BJ8 clearance-wise?

screenshot.1628.jpg
 
Last edited:
I use to use the 2004 for clearance until someone on a forum pointed out the smaller filtering surface would have less ability than the 2009. As I change the filter every year (3000 to4000 miles) this is probably a moot point.
 
I just want to mention, I have nothing against K&N. In fact, I have their air filters on both my Healeys and my '96 Ranger. The OP wanted to know what others are using and I think the 12-pack of Wixes is a good deal--NFI--since I use them on both my Healeys. I seriously doubt the K&N filters are worth the premium, but can't prove it. The fact that Wix states 'no warranty' on their race-only filters is prudent; else every racer who blows an engine would want a new one from Wix.
 
Back
Top