Offline
I am getting my gauges ready for reinstallation and the voltage gauge doesn’t seem quite right. The needle barely moves (up to about 11 V) when hooked up to a battery showing 12.50 volts. Resistance across the coils is 116.7 ohms. In the pics below, the wire looks rough but I think that’s just the wrapping. The two pics showing the gauge face show the needle at rest and then after 20 seconds or more.
Is this gauge toast? I wouldn’t think the slot adjustments - moving the brackets - would fix my issue, but I’m not sure what they do adjust. Resting point of needle? Sweep of the needle? Any gauge gurus out there?
Is this gauge toast? I wouldn’t think the slot adjustments - moving the brackets - would fix my issue, but I’m not sure what they do adjust. Resting point of needle? Sweep of the needle? Any gauge gurus out there?
Attachments
-
A79CC10B-AAE1-4A3C-96D2-961ED9141A3A.jpg67.3 KB · Views: 190
-
872093CA-43B0-4176-A6AC-9EF3AB158404.jpg64.8 KB · Views: 111
-
DD93ACD9-69CC-4AA2-B6FA-C3957C653EDA.jpg84.5 KB · Views: 180
-
2E901667-B75D-4BD1-B110-9824EDCC67FD.jpg40.6 KB · Views: 206
-
ECD3AC5E-7E92-4CCD-9336-743CC2B3C52C.jpg86.6 KB · Views: 127
-
59F80488-90D4-4867-A333-7B487FC7D41C.jpg90.2 KB · Views: 128