• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

sending units

Share this page

T

tri6

Freshman Member
Offline
I'm tired of replacing sending units for my 100/6, BN^. Is there a modern sending unit that upgrades the system? The original unit is a 1B2736. Thanks
 
What's the problem you are having with them? Have you modded the fuel line with a rubber hose between the tank and pump?
 
My fuel gage is also out and I have not yet tried to figure out the reason. Does having a rubber hose between the tank and pump cause a failure? As I said I have not looked yet. I am busy working on the brakes.
 
Scott--

The metal fuel line provides a ground connection for the pump. Crimp an eye-terminals onto a length of wire and run one end to one of the sender screws and the other to any good chassis ground.
 
Ok thanks I will look into that after the brakes are done.
 
Back
Top