• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Seat belts

Share this page

Bob Claffie

Bob Claffie

Jedi Knight
Country flag
Offline
Looking for the location for the outer halves of the seat belts on a 1959 BN6 . Car never had them before. Inner ends mounted to the side of the tranny tunnel. Can't figure out where to drill for the outside ones. Could it be just outside of the seat track?? Thanks, Bob
 
Bob Claffie said:
Looking for the location for the outer halves of the seat belts on a 1959 BN6 . Car never had them before. Inner ends mounted to the side of the tranny tunnel. Can't figure out where to drill for the outside ones. Could it be just outside of the seat track?? Thanks, Bob
Click to expand...

Hi Bob yes the location is just outboard of the seat tracks close to the rear of the seat. Take a look under the car and see if there is not an oval doubler welded to the floor board in that area. It also seems that the factory manual had installation instructions for that eye bolt---Keoke-?
Yep, See sction PPP Figure, PPP A and Section PPP. In the 100/3000 Workshop Manual.
 
Back
Top