• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Seat belts

Share this page

Bob Claffie

Bob Claffie

Jedi Knight
Country flag
Offline
Looking for the location for the outer halves of the seat belts on a 1959 BN6 . Car never had them before. Inner ends mounted to the side of the tranny tunnel. Can't figure out where to drill for the outside ones. Could it be just outside of the seat track?? Thanks, Bob
 
Bob Claffie said:
Looking for the location for the outer halves of the seat belts on a 1959 BN6 . Car never had them before. Inner ends mounted to the side of the tranny tunnel. Can't figure out where to drill for the outside ones. Could it be just outside of the seat track?? Thanks, Bob
Click to expand...

Hi Bob yes the location is just outboard of the seat tracks close to the rear of the seat. Take a look under the car and see if there is not an oval doubler welded to the floor board in that area. It also seems that the factory manual had installation instructions for that eye bolt---Keoke-?
Yep, See sction PPP Figure, PPP A and Section PPP. In the 100/3000 Workshop Manual.
 
Back
Top