• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

seat belt intallation in late BJ8

Share this page

00
John_Progess said:
Patrick,
My car is an early 64 phase I. The only studs on the rear fender wells are two 5/16" studs on each fender well that receive the chrome acorn nuts.--- :savewave: Those studs are for mounting driver shoulder seat belts.

Keoke,
About how high can the dual lock assembly stick up above the seat sourround?--

The type attached to springs will lay down if you lower the luggage rack-

On my car the entire rear seat back/luggage platform was missing. I have a pattern so I can make one. Thanks for the help and have a good day!--- :thankyousign: Good show Greg :thumbsup:
------------------------------------------------Keoke
John
Click to expand...
 
John,

If you have a pattern/drawing for the rear seat back/ shelf, can you share? I have my original, but it is deformed and I have to decide how to replace some of the panels.

Jerry
 
Jerry,
I have a sample of all the pieces that makeup the rear parcel shelf. Are you looking for a particular piece or do you need a dimensional drawing of everything? Thanks and have a good day!

John
 
Jerry,
You can borrow mine. I also want to recover mine. It is now off the car. I need to remove the metal and get it replated.
 
Mine has some warped wood and a bent metal shelf. I was looking for the drawing so I could re-fabricate. We put in the vinyl and carpet in the back seat yesterday and it looks pretty good. I still think there should have been thicker padding under the vinyl. It does not look too comfortable.

Jerry
 
Back
Top