• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 Routing Speedo cable for a J type tranny in my TR250

Share this page

Got_All_4

Got_All_4

Luke Skywalker
Country flag
Offline
Got my tranny in and now trying to decide what is the best way to route the speedo cable. I do have a 90* adapter and a 73" cable. Figure it's got to be the same as a later TR6. Not sure if going under the tranny or over it and the back side of the engine.
 
Try to get a high temp grease that will not melt or separate or Lithium. Pull the cable out of housing and wipe lube as you slid it back in, a light film is all that is required with a smooth bend gauge should hold steady. Madflyer
 
Back
Top