• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR6 Routing Speedo cable for a J type tranny in my TR250

Share this page

Got_All_4

Got_All_4

Luke Skywalker
Country flag
Offline
Got my tranny in and now trying to decide what is the best way to route the speedo cable. I do have a 90* adapter and a 73" cable. Figure it's got to be the same as a later TR6. Not sure if going under the tranny or over it and the back side of the engine.
 
Try to get a high temp grease that will not melt or separate or Lithium. Pull the cable out of housing and wipe lube as you slid it back in, a light film is all that is required with a smooth bend gauge should hold steady. Madflyer
 
Back
Top