• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Reproduction tachometer drive quality?

Share this page

I

ichthos

Darth Vader
Country flag
Offline
I got an estimate of about $100 to rebuild my tach drive (the part the shaft turns through is worn, so it is not something I can repair). I checked Moss and it costs about $80 for a reproduction tach drive. I admit I am always leary about reproductions. Any advice on which way to go?
Kevin
 
Rebuild! Unless the quality has greatly improved the reproductions are IMHO junk!
I have a spare and managed to make a good one out of 2 bad or I would eliminate the mechanical drive before fitting the new replacement.
A replacement drive came on my BE but parts stash saved me!

Kurt
 
Kevin,
You have a PM

dug
 
I also wanted an OEM unit for my rebuild. I bought one, opened it up greased it, put it back together. It lasted about 20 seconds when I first started my car....flung it across the garage. I bought a moss unit, and it has been fine ever since!
Scott in CA
 
I separated a BE tach drive, cleaned it up, redrilled the fastener holes, lubed it up with molybdenum grease, used small bolts to assemble it and it has been working well for a couple of years now.
 
Back
Top