• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

replacing fulcrum pin

Share this page

WALTER

WALTER

Jedi Hopeful
Offline
Moss sent me two cork washers with the fulcrum pin repair kit. They seem awful large to go between the swivel pin and the A arm. The ID's are so much larger than the fulcrum pin.

Thanks,
Walter
 
They should be two different inner diameters Since the fulcrum pin is bigger on one side that the other. They do swell a bit too.
 
In any case, that's where they go.
 
The ID of the corks is not meant to match the pin, but rather the OD of the threaded bushing in the arm. The corks do not turn.

Peter
 
Have a good time putting those corks in and lining everything up at the same time. An extra hand is helpful.

Mark
 
Gesh, I had no prob at all.
 
Odd but I'll do it.

Thanks a lot,
Walter
 
Back
Top