• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

replacing fulcrum pin

Share this page

WALTER

WALTER

Jedi Hopeful
Offline
Moss sent me two cork washers with the fulcrum pin repair kit. They seem awful large to go between the swivel pin and the A arm. The ID's are so much larger than the fulcrum pin.

Thanks,
Walter
 
They should be two different inner diameters Since the fulcrum pin is bigger on one side that the other. They do swell a bit too.
 
In any case, that's where they go.
 
The ID of the corks is not meant to match the pin, but rather the OD of the threaded bushing in the arm. The corks do not turn.

Peter
 
Have a good time putting those corks in and lining everything up at the same time. An extra hand is helpful.

Mark
 
Gesh, I had no prob at all.
 
Odd but I'll do it.

Thanks a lot,
Walter
 
Back
Top