• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Spitfire Removing cap over front hub on Spit

Share this page

A

AustinJim

Senior Member
Country flag
Offline
I want to remove the front hub on my 78 Spit. The book says the small cap (about 1.5" in diameter) covering the nut can be removed by screwing in a #10 UNF setscrew. What size is a #10 UNF in terms I can use here in the US? Could it be a #10 fine thread bolt? Just want to be sure so I don't strip the threads with the wrong size.
Thanks!
 
[ QUOTE ]
What size is a #10 UNF in terms I can use here in the US? Could it be a #10 fine thread bolt?

[/ QUOTE ]

I believe that is correct... but in my experience you are likely to strip the threads anyway if the cap has not been off for a log time. There are just a couple of threads in what is a stamped sheet metal cap so they can't take much tugging.

What I do: To remove the cap I use an eye bolt about 2" long. Rather than insert and pull I insert it until it makes contact with the end if the stub axle... then tighten, wiggle, tighten some more, wiggle some more -- if all goes well the cap is neatly drawn off the hub.

With the cap off (or on the replacement cap I get after using channel-locks to remove the old cap) I JBWeld a nut inside the cap to backup the threads (have to do this with a bolt in place so the threads all align). This plus some grease or anti-sieze on the lip plus occasional removal will make things easy in the future.
 
You can also try a self-tapper metal screw of the appropriate size. Screw it in enough to get a good bite and then wiggle the cap off with it. It will mess up the cap a little bit, but that's what the nave plates (cool British term, eh?) are there to hide.
 
Back
Top