TR2/3/3A Rear seat

[Arrow]

I am now building my rear seat bottom that sits on the shelf (later model post 60k) and have seen several photos showing various thicknesses. Mine is gone as it got wet. I called Moss but they are working from home. I’d appreciate some rear seat photos and thickness measurement. The end of a very long restoration is finally drawing near.

 

[CJD]

Sorry, gave you all I have on your other thread.

 

[Graham H]

This may help.

Graham

 

[Arrow]

Thank you! Those dimensions are exactly what I needed. Do you perhaps know how thick (bottom of plywood to top of leather/vinyl is.

 

[DavidApp]

I cut my ply from a sheet of 3/4" and used the dimensions in the last drawing.
Got the foam and covering from Skinner in the UK. The foam appeared to be too thick but I found that by compressing it with clamps I could start to get the staples in the board. Tuned out great.

David

 

[Arrow]

Thanks David, how thick is the finished product. It looks terrific! Tom

 

[Arrow]

We are only 75 miles apart maybe our TRs can cross paths.

 

[DavidApp]

I am on vacation at the moment so I can't get a measurement for you.

A get together would be great. I am in Macon.

David

 

[Graham H]

My pre 60K is 2 1/2 inches from bottom of base board to top of vinyl.

Graham

 

[DavidApp]

Sorry for the delay in posting the photos.

Back from Vacation now.

This is what I have on my rear seat. If I had not pulled as much material around to the underside the seat would have been thicker. I had a struggle getting the foam pad compressed enough to staple the edges.

David