TulsaFred
Jedi Warrior
Offline
I have my rear hubs off the bugeye and plan to renew the o-ring, paper gasket, and oil seal if possible. However, I dont want to replace the bearing which is good and tight and either original or a long ago replacement which Inanticipate is better quality than the bearings currently available at the parts houses.
1. Does the bearing have to come out of the hub to replace the oil seal?
2. Can the bearing be removed and replaced without "popping" it or otherwise damaging it?
3. Tips on the process and tools needed?
I have read many previous threads and Gerards write up, but remain unclear on these points.
Thanks for any help.
Fred
1. Does the bearing have to come out of the hub to replace the oil seal?
2. Can the bearing be removed and replaced without "popping" it or otherwise damaging it?
3. Tips on the process and tools needed?
I have read many previous threads and Gerards write up, but remain unclear on these points.
Thanks for any help.
Fred