I have the two sprockets on the crank and cam aligned with #1 & #4 at TDC, keyway down. Is there anything else I need to do , as far as aligning the valves, before I install the chain?
The builder installed new cam bearings, but did not re-install the Cam bearing 3 bolts! I do not have the pan on yet. Is there a safe way to re-install the bolts, without binding the camshaft? If I hadn't noticed this, I'm sure I would have lost a lot of oil.
Dick
The builder installed new cam bearings, but did not re-install the Cam bearing 3 bolts! I do not have the pan on yet. Is there a safe way to re-install the bolts, without binding the camshaft? If I hadn't noticed this, I'm sure I would have lost a lot of oil.
Dick