• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR4/4A Rally lights/badge bar for TR4 source

Share this page

This is what I'm talking about [img:center]
rallylightbar.jpg
[/img]
 
Revington does that bar as well I think.
 
I made mine by using a polished aluminum bar and running it through turned upside down badge bar holders. I then bolted to it a piece of flat stock the same width of the badge holders and that bolts to the licence plate holes. Depending on how long you want the bar the end braces have a twist to them and go behind the front bumper then bolt to the bumper brackets or over rider mount. Now mine is a TR250 and the over riders are farther apart than a early TR4. I tried to find a pic because I know I sent it to someone but could not find it. I'll keep looking though. Mine hold a couple badges and 2 driving lights.
 
The front licence plate covers the braces too. I did have to put a slight bend in the bar so it would follow the curve of the bumper. It is very strong and there is very minimal light shaking while driving. Only large pot holes do I notice any shaking and we have a lot of them in Ohio. So if your just butting on badges no worries.
 
Back
Top