• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

MGB-GT Question - removing front bearings

Share this page

drooartz

drooartz

Moderator
Staff member
Gold
Offline
How do I remove the inner bearing (closest to the hub) and distance piece? Tap it out from the outside?
 
3/8" diameter long brass drift and tap it out from the "outside." There are two undercut recesses in the casting, 180° opposite each other to allow you to tap equally for removal... the spacer tube will move around enough to allow you to do it. May want to clean the hub thoroughly with mineral spirits to see what the old grease is hiding. :wink:
 
Thanks, Doc. Will tackle shortly and report back.
 
Back
Top