• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Qucik Question #1 Clutch slave cylinder

Share this page

JPSmit

JPSmit

Moderator
Staff member
Silver
Offline
how does it come apart? I have it off the bracket and the end rubber cap off - what next?
 
Smack open end against wood / non-marring surface, to bring plunger past lip. Or, just pull it out with your finger using suction. Spring is loose behind plunger, which houses rubber seal.

I had no success rebuilding mine, due to scored outer bore... replacement not prohibitively expensive, but not cheap either. ($48 from Moss, for ex.)

SPM-024_1.gif
 
should be a inside diameter cir clip (spring steel retainer). use your hande cir clip pikers and remove it, the rest just falls out. pay attention to the order and orientation.

mark
 
Back
Top