• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Piston fit

Share this page

W

wdp

Senior Member
Offline
Started to rebuild a motor for my BGT, and the block turned out to be bad. I was going to use a block from a 67, but have switched to an 18V, my question is can I use the circlip pistons on press fit rods? I am rebushing the rods.
 
Hap can explain that one...but, yes, you can have the pressed rods modified to take circlip pistons...have to drill the bore to take the bushing & drill an oil hole.

Where's Hap when you need him?
 
Back
Top