• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Piston fit

Share this page

W

wdp

Senior Member
Offline
Started to rebuild a motor for my BGT, and the block turned out to be bad. I was going to use a block from a 67, but have switched to an 18V, my question is can I use the circlip pistons on press fit rods? I am rebushing the rods.
 
Hap can explain that one...but, yes, you can have the pressed rods modified to take circlip pistons...have to drill the bore to take the bushing & drill an oil hole.

Where's Hap when you need him?
 
Back
Top