• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A Part Identification

  • Thread starter Thread starter tdel
  • Start date Start date

Share this page

T

tdel

Guest
Guest
Offline
Hi All, I am back now, engine rebuild is finished and the mechanic is putting the car back together. Now after several months we have forgot where the parts in the photo go....I am sure folks here can identify. We think the semi-circular parts go on fan assembly. I cannot identify the bracket....
 

Attachments

  • Fan.jpg
    Fan.jpg
    200.8 KB · Views: 212
  • Bkt.jpg
    Bkt.jpg
    200.1 KB · Views: 209
the first is for the fan shaft at the front of the crankshaft. The second one I have seen it, but can't remember where it goes.... Maybe the front suspension?
 
2nd part is one of the two brackets that hold your block rubber motor mount in place. Four are needed for engine install.

Pat
 
The top piece in the left photo does look like the weight used to balance the original fan, P/N 107858. But I don't recognize the bottom one. Looks kind of like a weight that someone has cut down?

As Pat said, the right photo is the "steady bracket" that goes on either side of the front motor mounts, PN 106428. But most cars (including mine) seem to be missing those pieces, as they make it a lot harder to install the mounts.
 
Yes, well, there was only one bracket on my car (supposed to be 4 as Pat mentioned). I guess that is why we could not figure out what it was. Memory fades after a few months! Good news is that the car should be running by week's end
 
RedTR3 said:
Yes, well, there was only one bracket on my car (supposed to be 4 as Pat mentioned). I guess that is why we could not figure out what it was. Memory fades after a few months! Good news is that the car should be running by week's end
Click to expand...
I ended up buying a couple of those motor mount brackets from Moss. My car had two originals and two that were homemade by some PO. I'm sure my mounts will be much stiffer than yours, Marv! Hah.

Pat
 
Back
Top