-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A Oil pressure readings
- Thread starter karls59tr
- Start date
Share this page
Online
Mine is
40/50 idle (800/1000 rpm)
70(+) over 2000rpm
Hot
40/50 idle (800/1000 rpm)
70(+) over 2000rpm
Hot
CJD
Yoda
Offline
Above 2000 rpm you should set the pressure regulator to 70psi. Idle, then, shows the amount of clearance in the engine. You should have no less than 10psi. Anything greater than 10 is gravy. If you do drop below 10psi, you can use thicker oil to stretch a rebuild.
Then, remember that the dash gage may or may not show the correct pressure. If you are really curious, it would be best to use a decent gage tapped into the line.
Then, remember that the dash gage may or may not show the correct pressure. If you are really curious, it would be best to use a decent gage tapped into the line.
That's good news. That's the reading I'm getting.
