• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

O rings/gaskets for instruments

Share this page

PAUL161

PAUL161

Great Pumpkin
Silver
Country flag
Online
Is there a known supplier for O rings or flat gaskets that fit between the glass and chrome faces of instruments? I haven't found anything other than sizeable thin O rings. PJ
 
Paul - I've had luck with McMaster-Carr, when I can't find an o-ring or gauge seal that fits.

www.mcmaster.com

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
www.mcmaster.com www.mcmaster.com

Tom M.
 
Paul, the o-ring gaskets found in the canister type oil filters work if you can't easily find "correct" ones. Cutting the oil filter gaskets with a razorblade to correct diameter and using "super glue" to reattach the ends. Used 'em for decades as such, set the seam to the bottom of the gauge if it's noticeable at all. Think: splicing recording tape or movie film. The joint is usually unnoticeable if you're careful.

And usually the gaskets are "free" in that there are a couple in each filter box. :D
 
Never needed to find out! I likely have a "lifetime supply" here!
 
Thanks fellas, I have about a dozen ? of those filter flat gaskets still in plastic bags never gave them a thought. Thanks again. (y)
 
The thinnest ones seem to work. The thicker ones can work as the OD gasket between dash and instrument bezel, BTW. Same cut-to-fit job.
 
Thanks Doc, much appreciated! (y)
 
Back
Top