• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

O rings/gaskets for instruments

Share this page

PAUL161

PAUL161

Great Pumpkin
Silver
Offline
Is there a known supplier for O rings or flat gaskets that fit between the glass and chrome faces of instruments? I haven't found anything other than sizeable thin O rings. PJ
 
Paul - I've had luck with McMaster-Carr, when I can't find an o-ring or gauge seal that fits.

www.mcmaster.com

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.
www.mcmaster.com www.mcmaster.com

Tom M.
 
Paul, the o-ring gaskets found in the canister type oil filters work if you can't easily find "correct" ones. Cutting the oil filter gaskets with a razorblade to correct diameter and using "super glue" to reattach the ends. Used 'em for decades as such, set the seam to the bottom of the gauge if it's noticeable at all. Think: splicing recording tape or movie film. The joint is usually unnoticeable if you're careful.

And usually the gaskets are "free" in that there are a couple in each filter box. :D
 
Doc - is there a source for those gaskets if you don't want to have to buy the complete oil filter?
 
Never needed to find out! I likely have a "lifetime supply" here!
 
Thanks fellas, I have about a dozen ? of those filter flat gaskets still in plastic bags never gave them a thought. Thanks again. (y)
 
The thinnest ones seem to work. The thicker ones can work as the OD gasket between dash and instrument bezel, BTW. Same cut-to-fit job.
 
Thanks Doc, much appreciated! (y)
 
Back
Top