• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Newbie

Share this page

J

jgoss

Member
Offline
Hi,

Just joined and wanted to say hi.
I'm the shall I say proud owner of a 65 AH Sprite. I've been doing a rolling restoration. The rolling has stopped for paint stripping, floorpan replacement and a post replacement.
I saw a posting about floorpan replacement and a lot of talk of bracing the doors while doing it. You all have me scared now. The way I understand it is you tack a brace from A post to B post?

Any tips are appreciated.

John Goss
 
John, I did the same type of restoration on my 1971 Midget. It is critical to prevent the body from sagging when the floor and rotten part of the A pillar are removed, or your door will not fit properly. If your sills are ok they should prevent any sag, but to be safe I would construct some bracing across the door for insurance. You can see some pictures I took of my restoration and fitting of pannels at:https://home.comcast.net/~r67cat/wsb/html/view.cgi-home.html-.html click on Photos.
Let me know if I can provide more specific help. Good luck, Rick
 
jgoss,
welcome to THE forum for people of our affliction.
Lots more help will be along shortly.
Post often and enjoy! /ubbthreads/images/graemlins/thumbsup.gif
 
Welcome to the looney bin, John.
The first advice I would offer on your floor pan project is to take plenty of measurements before you start.
I use 1" square tubing, from A post to B post, and a diagonal from one A post to the other B post. You don't have to bridge weld them in, just a couple of good tacks. This keeps the body from shifting when you remove the pans and/or sills. If you are doing the sills as well, do them first, verify that everything is still in place, then tackle the floor. I normally will tack the sills on, and take more measurements before the final welding. It's a lot easier to remove and shift things if they're only tacked.
I've not run into floor pans that were narrower than they should be, but I haven't bought any recently. I still have a couple of sets that I got a few years ago. One for a Bugeye, and I think the other set is going into a '64.
Jeff
 
Hi John, and others, I just joined this very minute. I was given a '76 Midget 2 weeks ago and am trying to figure out how to make it roadworthy. It has been sitting (inside) for 12 years and needs a little body work (dents)but has virtually no rust. First I have to get it running, free the clutch, brakes etc. Thanks in advance for the help that I've already seen.
John-Peter Smit
 
Welcome to you both! I'm in almost the same boat as you, JPSmit-- given a '76 Midget that had been sitting inside, but only for 6 years. I was lucky; I only had to work with it for an afternoon to get it started!
 
Welcome to you as well, J-P. Glad to see another example being restored to its rightful place on the road. Actually, it's more of "beside" the road. /ubbthreads/images/graemlins/grin.gif
Just kidding, they are fairly reliable cars, once you learn the tricks, incantations, and swear words.
We're here to help.
Jeff
 
Back
Top