• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

New Axle spline

Share this page

G

Guest

Guest
Guest
Offline
I got new axles, splines, bearings, seals and re-built the rearend. The splines were tough to get on the axles but we did. Now that I have put it all together the spline hub and the hub that hold the axle to not seal completely. After a lot of investigation I have determined the ridge on the back of the spline hub is too deep or the bearing is too deep.

ax.jpg


To fix it I am going to cut a shim out of metal. Has anyone else had this problem?

Gary
 
WOW! That's pretty slick! Have you figured out how to make the E-brake work?
 
I'll proabably do like I have in the Pantera and do a line lock. I thought of some other things but the line lock is simple.
 
I made a mount for a panhard rod on the rear end. I welded it when the axle was out which was good. Kept from boiling the oil.

G
 
Back
Top