• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Lubricant Question

Share this page

B

BWillis

Jedi Knight
Offline
I just need to confirm my findings after hours of reading on this forum on the subject.

I plan to use a 20w50 oil in my 1275. In my ribcase I should use a 50wt standard engine oil, or is it okay to use the same multi-viscosity oil as in the engine?

How much of each should I need?

Thanks,
 
And I read that I should fill the transmission through the shifter opening? Roughly how much does an empty rib-case take?

Thanks again....


(I know Jack knows off the top of his head /bcforum/images/%%GRAEMLIN_URL%%/laugh.gif )
 
Tranny holds 2.7 pts.

Engine holds 7.8 pts.

Use the same oil you put in the engine 20-50

Pump it into the tranny through the filler hole. Bugeyes have a rubber plug by your right knee for this. Use one of the 3 buck pumps that screws on a quart bottle. When full it will run out.
 
Depends on the wear and tear inside the engine. I put 20w/50 in mine during July/August and had a lot of shifting problems. It was also 98-100 degrees during the day during that time. I switched to Castrol 40HD and so far my shifting issues have diminished quite a bit.
 
AhhHemm, I was talking about new units or rebuilt of course.
 
US pints my friend

Like one quart for the tranny and 5 for the engine, start checking at four as 5 is a bit much although a bit will need to go into the filter.
 
Back
Top