• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR4/4A Lower fulcrum brackets

Share this page

Rut

Rut

Obi Wan
Country flag
Offline
I picked up my frame from the shop after sandblasting and powder coating and really like the work they did. I want to have the lower fulcrum brackets powder coated as well, but I don't know if it will leave room for the poly bushings I plan on installing. The brackets came from TRF by way of Revington I believe and on two the studs are straight and parallel and on the other two they are not. Is this correct and should I powder coat?
Thanks, Rut
 
Rut, which lower fulcrum bracket are you referring to? Original p/n 139715, replaced by a two-stud p/n 148691? Or the lower wishbone, 307209, 307210?

In general, I would mask off any areas where a bushing will go. IMHO, bushings should be greased and ride against metal. (Even though the powder coated finish looks fantastic!)
 
Mike,
They are the extended 2 stud TR6 style and I spoke with Albert at TRF this morning. He's checking for 2 brackets with straight studs and he'll send them out once he locates them. I will mask off the threads and inside of the bracket where the bushings make contact just to make sure.
Thanks, Rut
 
Good to hear. My studs were not quite parallel either, but there is enough slop in the assembly that the slight out of square did not affect assembly.
 
Back
Top