• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Light switch knob removal?????

Share this page

S

steve_sims

Member
Offline
Howdy All, I just got used dash light switch to replace the dead one in my car. My question is , How do you remove the knob to install switch in dash? There is a hole on the side of the knob with a "pin" inside. I have tried pushing in pin and pulling knob but am afraid to use much force. Don't want to screw up thru stupidity. Thanks Steve
 
Steve:
Push the pin in as far as you can, pull straight out on the knob {No Twisting} It may be stuck on there pretty good from all the accumulation of crud over the years. You may want to spray it with some P.B. blaster or something simular to help loosen up the crud. The hole in the knob has a flat side twistin` it will surely break it!
 
Thanks Kerry, I had put a drop of Kroil in the hole before my first post . Just went down and gave the punch a light tap and the pin went in and knob came off. Thanks Again , Steve
 
Back
Top