• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR4/4A Lever Shock Fluid Level

Share this page

RJS

RJS

Jedi Warrior
Country flag
Offline
Hey,

Shocks are installed in the car - car on jack stands with suspension in full droop. I just pulled the top filler screw of the top of my lever shocks to check the level. Immediately a very clean oil began pouring out. I immediately replaced the screw.

Should I be concerned they are over filled? I've read the fluid needs air space to expand. As far as I know, the shocks have been like this for the past 14 years and never any leaks. Could this be because of the position of the supension?

Thanks

Bob
 
The position of the suspension shouldn't matter. As one piston goes up, the other goes down, the level should stay much the same But if they've been OK, then I'd leave it be. Sounds like some air got worked into the lower half (below the pistons) while they were off the car.

If you want, you could take the arm loose and work it up and down a few times to work the air back to the top. But it will happen quickly enough when you start driving, so I wouldn't worry about it.
 
Back
Top