Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I installed LED bulbs for the brake / turn signal lights on my BT7 today. Oddly, the left side worked fine without adding a resistor, while I had to add the resistor to the right side to get it to blink. To avoid messing with the wiring at the lights I wired the resistor in at the flasher unit. Very happy with the brighter and more instantaneous brake lights.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
LED Brake / Turn Signal
- Thread starter Jack T
- Start date
Share this page
Bob_Spidell
Yoda
Offline
Hi Jack,
Where did you acquire the brake bulbs? Is your car positive ground?
TIA,
Bob
Where did you acquire the brake bulbs? Is your car positive ground?
TIA,
Bob
Offline
Moss has them.
I purchased the bulbs at Walmart, $20 for a two-pack. They're Sylvania ZEVO, lifetime guaranteed for as long as you own your car, supposedly. They look different from the tower-type bulbs most vendors are selling. I have changed my car over to negative ground, primarily to install a cell phone charger, which by the way I also found at Walmart. $10 for a very elegant-looking dual-USB charger that I mounted on the underside of the parcel shelf.
Bob_Spidell
Yoda
Offline
"These bulbs fit factory sockets, but require that your car be negative ground."