Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Hello all,
My '70 GT6+ was repainted ~25 years ago. The painter removed 3 labels, but did not replace them. I do not recall exactly where these labels were. I'd like to put them back in their original locations. At least 2 were on the underside of the bonnet on the driver's side near the upper (back) edge. Can anyone tell me where these labels should go (maybe a picture)?
The labels: One is a metal plate 105 mm x 69 mm "Tyre sizes & Pressure..." and "Capacities"
Two are plastic labels. One is 120 mm x 63 mm "U.S. FEDERAL STANDARDS. CONTROL OF AIR POLLUTION." This one has marks across it where the full width seal just below the windshield marred it.
The other is 116 mm x 54 mm "TRIUMPH G.T.6. THIS VEHICLE HAS TRIUMPH EMISSION CONTROL..."
Also, on the left side under the bonnet below the shelf where the brake and clutch masters sit, near the bonnet latch, something may have been riveted on just above a riveted on metal strip (painted over) that has apparently the model series # "75004 KD" which is not the serial number. What could have been riveted there? It was not the metal tag described above; it was glued on somewhere.
Any help will be greatly appreciated.
Hoodat
My '70 GT6+ was repainted ~25 years ago. The painter removed 3 labels, but did not replace them. I do not recall exactly where these labels were. I'd like to put them back in their original locations. At least 2 were on the underside of the bonnet on the driver's side near the upper (back) edge. Can anyone tell me where these labels should go (maybe a picture)?
The labels: One is a metal plate 105 mm x 69 mm "Tyre sizes & Pressure..." and "Capacities"
Two are plastic labels. One is 120 mm x 63 mm "U.S. FEDERAL STANDARDS. CONTROL OF AIR POLLUTION." This one has marks across it where the full width seal just below the windshield marred it.
The other is 116 mm x 54 mm "TRIUMPH G.T.6. THIS VEHICLE HAS TRIUMPH EMISSION CONTROL..."
Also, on the left side under the bonnet below the shelf where the brake and clutch masters sit, near the bonnet latch, something may have been riveted on just above a riveted on metal strip (painted over) that has apparently the model series # "75004 KD" which is not the serial number. What could have been riveted there? It was not the metal tag described above; it was glued on somewhere.
Any help will be greatly appreciated.
Hoodat
