RickB
Yoda
Offline
I've been back at Franks hood with the Rustoleum rattle cans again. Today (after fixing the brake lights) I wet sanded the brown rustoleum rattle can paint job consisting of three coats of 78 Midget brown. (they might as well call it that, it's such a match!).
So today I planned on spraying on the "crystal clear coat".
I sanded and got it smooth enough and wiped it all down and sprayed away. There were a couple runs so I waited a bit & sanded them out and then sanded the whole thing again and sprayed it one more time.
The can says it should be used between 70 - 80 degrees.
It's 77 out there.
I've got shade. A nice 12 x 12 pop up shade tent thing.
So how come the coat is all kind of 'frosted' looking?
Have I done something wrong?
What next?
I'll go take a picture. Be right back.
So today I planned on spraying on the "crystal clear coat".
I sanded and got it smooth enough and wiped it all down and sprayed away. There were a couple runs so I waited a bit & sanded them out and then sanded the whole thing again and sprayed it one more time.
The can says it should be used between 70 - 80 degrees.
It's 77 out there.
I've got shade. A nice 12 x 12 pop up shade tent thing.
So how come the coat is all kind of 'frosted' looking?
Have I done something wrong?
What next?
I'll go take a picture. Be right back.