• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Is this hole original?

Share this page

chrpark

chrpark

Senior Member
Offline
My '62 Sprite Mk II under primer. This hole was covered by some sort of thin plate, attached with two self tapping screws. Maybe a way to try and make clutch slave easier, or speedo cable connection?
 

Attachments

  • 22613.jpg
    22613.jpg
    8.6 KB · Views: 140
Big oval one is the transmission fill hole. Usually covered with a rubber plug.
 
Small round one is standard and used to Lubricate the front U-joint on the Driveshaft.

Normally a round rubber plug fits there. BTW, the small round rubber plug acquires excess grease from the lubrication and deteriorates (transforms) into a small black lump that will saturate the back of your carpet and make it look bad!

BTDT

YMMV

Steve
 
Back
Top